Colloid &  Nanoscience  Journal

Colloid & Nanoscience Journal

Fabrication and characterization of PES based nanofiltration membrane using bio-inspired iron (III)-dopamine nanoparticles

Document Type : Original Article

Authors
1 Department of Chemical Engineering, Arak university, Arak 38156-8-8349, Iran
2 Department of Mechanical Engineering, Ayatollah Boroujerdi University, Boroujerd 69199-69737, Iran
Abstract
This paper presents a study on the modification of nanofiltration membranes with bio-inspired iron (III)-dopamine nanoparticles in a polymer solution. The membranes were produced using the immersion precipitation technique with the incorporation of dopamine, polyvinyl pyrrolidone, and dimethylacetamide. The study evaluated the properties of the nanocomposite membranes, including water content, surface morphology, and their performance was characterized through SEM, contact angle goniometry, pure water flux, and rejection of NaCl and humic acid. The findings revealed that membranes containing 0.1 wt.% bio-inspired iron (III)-dopamine nanoparticles exhibited the best overall performance, with enhanced hydrophilicity, anti-fouling properties, and salt rejection efficiency. This optimal concentration also minimized fouling and improved the flux recovery ratio compared to other concentrations, highlighting its potential for water treatment applications
Keywords

[1] J. D. Seader, E. J. Henley, D. K. Roper, Separation process principles. Wiley, New York, Vol. 25 (1998).
[2] E. Drioli, L. Giorno, Comprehensive membrane science and engineering. Newnes, Vol. 1 (2010).
[3] Y. Li, S. Wang, H. Wu, J. Wang, and Z. Jiang, Bioadhesion-inspired polymer–inorganic nanohybrid membranes
with enhanced CO2 capture properties. J. Mater. Chem., 22(37) (2012) 19617–19620.
https://doi.org/10.1039/c2jm34347a.
[4] L. Qi, Z. Xu, Lead sorption from aqueous solutions on chitosan nanoparticles. Colloids Surf. A, 251(1-3) (2004)
183–190. https://doi.org/10.1016/j.colsurfa.2004.03.001.
[5] J. Mukherjee, D. Malhotra, S. Gautam, and M. N. Gupta, Green synthesis of nanocomposites consisting of silver
and protease alpha chymotrypsin. Ultrason. Sonochem., 20(4) (2013) 1054–1061.
https://doi.org/10.1016/j.ultsonch.2012.12.014.
[6] M. F. Ali, S. Abbas, A review of methods for the demetallization of residual fuel oils. Fuel Process. Technol.,
87(7) (2006) 573–584. https://doi.org/10.1016/j.fuproc.2006.01.004.
[7] P. Marchetti, M. F. Jimenez Solomon, G. Szekely, and A. G. Livingston, Molecular separation with organic solvent
nanofiltration: a critical review. Chem. Rev., 114(21) (2014) 10735–10806. https://doi.org/10.1021/cr500075k.
[8] H. Yacubowicz, J. Yacubowicz, Nanofiltration: properties and uses. Filtr. Sep., 42(7) (2005) 16–21.
https://doi.org/10.1080/19443994.2014.943061.
[9] R. R. Sharma, R. Agrawal, S. Chellam, Temperature effects on sieving characteristics of thin-film composite
nanofiltration membranes: pore size distributions and transport parameters. J. Membr. Sci., 223(1-2) (2003) 69–87.
https://doi.org/10.1016/S0376-7388(03)00233-9.
[10] L. Li, S. Zhang, X. Zhang, Preparation and characterization of poly(piperazineamide) composite nanofiltration
membrane by interfacial polymerization of 3,3′,5,5′-biphenyl tetraacyl chloride and piperazine. J. Membr. Sci., 335(1-
2) (2009) 133–139. https://doi.org/10.1016/j.memsci.2009.04.043.
[11] H.J. Zwijnenberg, S. M. Dutczak M. E. Boerrigter, M. A. Hempenius, M. W. Luiten-Olieman, N. E. Benes, M.
Wessling, and D. Stamatialis, Novel polyethersulfone nanocomposite membrane prepared by PANI/Fe3O4
nanoparticles with enhanced performance for Cu(II) removal from water. J. Membr. Sci., 415 (2012) 250–259.
https://doi.org/10.1016/j.memsci.2011.11.039.
[12] S. Zinadini, A. A. Zinatizadeh, M. Rahimi, V. Vatanpour, H. Zangeneh, and M. Beygzadeh, Novel high flux
antifouling nanofiltration membranes for dye removal containing carboxymethyl chitosan coated Fe3O4
nanoparticles. Desalination, 349 (2014) 145–154. https://doi.org/10.1016/j.desal.2014.05.012.
Volume 2, Issue 3
Autumn 2024
Pages 336-356

  • Receive Date 17 November 2024
  • Revise Date 12 January 2025
  • Accept Date 17 January 2025